ment Briggs & Stratton engine was equipped with a carburetor solenoid, it would not function. This is why it is important to have a diagram of the keyswitch when replacing engines, or replace the keyswitch with one that is compatible with all Briggs & Stratton alternator systems. 1 Ground (Used only with insulated panel) 2 To Carburetor Solenoid. Easy to Maintain Engine: With the Briggs and Stratton 208cc engine. Reliable Pump: An adjustable axial cam pump with Easy Start™ technology allows you to adjust the PSI from 1400 to 3000. Cleaning Versatility: Easily demolish dirt on a wide variety of surfaces with the 4 quick-connect nozzles (0 degree, 15 degree, 40 degree and Soap) equipment, contact Briggs & Stratton to ensure that the engine is appropriate for the intended use. Note: For all Go-karts use only a model 136200 series en-gine, which offers improved safety and performance. • Replacement engines should be the same model as the original engine, or be the Briggs & Stratton designated replacement engine. A. Refer to Engine Model, Type and Code Number that is stamped on the blower housing of engine. Engine type numbers such as 0123 01 are listed only as 0123 in most instances. The two digits (01 or 02, etc.) to the right of the space may be required for more accurate parts identification in some instances. The information on this page and the following pages is excerpted from the booklet "Data Handbook for early BRIGGS & STRATTON® Engines" compiled by Bob Learned. This booklet is a collection of specifications and data for early model BRIGGS & STRATTON® Cast Iron engines. The information shown here and in the booklet has been compiled from the MS3992_2004 50000 Engine Specifications Chart Ms3992 Torque Specifications Model Series Idle Speed Armature Air Gap Valve Clearance FORM MS-3992-10/04 E 2004 BRIGGS & STRATTON CORPORATION PRINTED IN U.S.A. If9zi3. COMMON SPECIFICATIONS FOR ALL SINGLE CYLINDER OHV ENGINE MODELS EXCEPT INTEK MODELS. BASIC MODEL SERIES. OIL CAPACITY Fl. Ozs. (Liters) ARMATURE AIR GAP INCHES (mm) TORQUE SPECIFICATIONS. TORQUE SPECIFICATIONS. TORQUE SPECIFICATIONS. TORQUE SPECIFICATIONS. VALVE CLEARANCE. The Briggs and Stratton Intek 8 horsepower engine has a maximum top speed rating per minute of 3600, so the engine cannot be over-spined or overwhelmed by the operator as it is mechanically governed. The Briggs and Stratton 8 horsepower engine is a single cylinder L-head engine with a sleeve of covering the aluminium cylinder and providing

briggs and stratton engine specs chart pdf